Filter
Top Products
3-2
DGPS port
1. Press the [MENU] key.
2. Press the software key labeled "CONFIGURATION".
3. Press the software key labeled "SETUP NMEA/DGPS PORT2".
4. Select "FORMAT" by the arrow key.
5. Press the software key labeled "EDIT" to display the following
message.
s FORMAT NMEA 0183
VER 1.5
▲▲▲
OUTPUT FORMAT
NMEA0183 Ver1.5
' NMEA0183 Ver2.0
RTCM104 (EXTRN)
RTCM104 (INTRN)
DGPS 3D
SETUP
PORT2
ENTER
CANCEL
▼
▲
RTCM104 (OUTPUT)
Figure 3-2 Output Format Display
6. Select NMEA version, external DGPS or internal DGPS by the
arrow key. The selected item is indicated by black button.
NMEA0183 Ver1,5/Ver2,0 :Select one when connecting
PC or RS-232C equipment.
RTCM104(EXTRN) :Select this when connecting
external DGPS beacon
receiver.
RTCM104(INTRN) : Select this for builtin internal
DGPS beacon receiver.
RTCM104(OUTPUT) :Select this when outputting
differential data of the
internal DGPS beacon receiver
to other GPS navigator.
Note1) Note that you cannot setup sentences when you select
RTCM104 at the format.
Note2) For RS-422 format, the level converter (IF-1432) is required
for connection of external equipment.
7. Press the software key labeled "ENTER" or the [ENTER] key.
8. Press the [PLOT] key to finish.