Filter
Top Products
Figure 13
Step Ten:
Use the removed cylinder head bolt to
mount the throttle actuator bracket as
shown.
Note: Bend the loom holder out of the way
temporarily to gain access to the bolt, and
then bend it back into place to hold the wire
loom & hose in place away from the throttle
actuator as shown in Figure 13.
Torque bolt 30Nm/21.5 ft.lbs
8
Figure 12
Figure 14
Step Eleven:
Remove the nut & lock washer from the
throttle arm of the carburetor as seen in
Figures 14 & 15.
Figure 15