Filter
Top Products
Install the bolt you just removed into the same hole
from the starboard side of the motor to the port side.
Put a little thread lock on the protruding end of the
bolt. Thread the bolt’s end in to the Standoff Nut
(item 1) as shown in gure 6 and tighten the it.
Remove the two rear bolts from the lower motor
vibration isolation mounting shroud as shown in
gure 7.
Again, install the bolts you just removed into the
same holes from the starboard side of the motor to
the port side. Put a little thread lock on the protruding
ends of the bolts. Thread the bolts into non-at side
of the Standoff Nut Plate (item 5) as shown in gure
8 and tighten the them.
Page 5
Figure 6
Figure 7
Figure 8
Step Two:
Step Three:
Step Four: