Filter
Top Products
3
2
PANEL DESCRIPTION
CAUTION!:
When attaching or releasing a battery pack, make sure the
rubber seal is set in the groove of the battery pack/case
correctly. If the seal is not neatly in the groove it may be
damaged when attaching the battery pack/case.
If the seal is damaged, water resistant is not guaranteed.
OPEN
LO
C
K
Screw position
when removing battery
OPEN
L
O
C
K
Screw position
when attaching battery
Make sure both the rubber seal (purple) is set to the groove
correctly and dust etc. does not adhere to it.
Battery pack/case
Battery pack/case
Rubber seal
Groove
Correct position
Incorrect position
NOTE:
When attaching a battery pack/case, make sure dust etc.
does not adhere to the rubber seal. If dust etc. is on the seal
when attaching a battery pack/case, the water resistant may
be reduced.
ï BATTERY CASE RELEASE SCREW
To remove the battery case:
Turn the screw counterclockwise, then pull the battery pack
in the direction of the arrow as shown below.
To attach the battery case:
Insert the battery case in the IC-M21 completely, then turn the
screw clockwise.
NOTE: When removing or attaching the battery case, use a
coin or flat-head screwdriver to loosen or tighten the
bottom screw.