Filter
Top Products
Setup
16 313888E
8. Spray test pattern. Aim applicator at floor. Turn air
valve ON. Move applicator to spray surface.
9. Adjust air valve and/or select alternative nozzle size
(4 - 10mm) for desired finish.
Air Assisted Spray
(Air Spray Trigger Gun)
1. Prepare material, page 13. Place material hose in
supply pail.
2. Turn on/off switch OFF.
3. Turn air valve OFF. Connect applicator to material
hose and air hose. Air supply minimum require-
ments vary with material thickness and desired
thickness.
4. Turn on/off switch ON.
5. Hold applicator over material pail, trigger on, and
turn pump ON using applicator switch on hose.
NOTE: Remove spray disk then set material flow to
prevent material from back-flowing into air passages
of gun.
6. Turn pump control clockwise and adjust engine
throttle to lowest setting until desired material deliv-
ery rate is achieved.
NOTICE
IF PUMP IS STOPPED LONGER THAN 3 MIN-
UTES, TO AVOID PUMP PLUGGING:
• Relieve pressure in the pump (See Pressure
Relief procedure - page 10).
• Recirculate the material by pumping back into
original material container.
Due to the high pressure fluid emitted, a strong recoil
action may occur when you trigger this gun. If you are
unprepared, your hand could be forced back toward
your body or you could lose your balance and fall,
resulting in serious injury.
ti13646a
ti11798a
6 mm
8 mm
10 mm
4 mm
ti10796b
NOTICE
DO NOT USE MATERIALS THAT CURE RAPIDLY!
Materials with a fast curing time could plug the pump
hose, gun, or applicator.
ti21263a
ti10795b
ti21243a
ti8794a