Filter
Top Products
Cleanup
313888E 19
9. Run pump until cleaning ball exits material hose.
Save cleaning ball (Base Coat Only).
10. Turn on/off switch OFF and turn prime/drain valve to
DRAIN. Clean outside of pump and suction tube
with brush and water.
11. Connect applicator to material hose. Close
prime/drain valve.
12. Turn on/off switch ON.
Base Coat Pump: Turn prime switch ON, or appli-
cator switch on material hose.
13. Run pump until clean water flows from applicator.
14. Add additional water and repeat steps 12 - 13 if nec-
essary.
15. Open prime/drain valve and turn prime switch ON to
flush valve.
16. Turn on/off switch OFF when valve is thoroughly
flushed.
17. Open over pressure relief valve and turn prime
switch ON to flush valve.
ti4551c
ti10796b
ti14632a
ti21038a
ti10795b
ti13641a ti21039a
ti13839a
ti14632a
ti10796b
ti13633a