Filter
Top Products
Digital Tracking System (DTS)
313888E 21
Digital Tracking System (DTS)
Main Menu
Close cover when spraying to protect display.
1. Perform Startup steps 1 - 2.
• Open drain valve
• Turn pump control counterclockwise to lowest set-
ting
• Set applicator switch to OFF
2. Start Engine, page 12. Display will momentarily
show which pump is installed (Base or Top) and
then Flow 1, 2, or 3 (if Base Coat pump is installed).
Pressure display appears, then dashes appear
when pressure is less than 60 psi (4 bar, 0.4 MPa).
NOTE: Information other than pressure cannot be
accessed if applicator switch is ON. And, if system pres-
sure is greater than 200 psi (14 bar, 1.4 MPa), the dis-
play will revert back to pressure after 3 seconds.
3. Short press DTS button to display installed pump.
4. Short press DTS button to move to Engine RPM.
5. Short press DTS button to return to Pressure.
To Change Pressure Units:
Press and hold (8 seconds) DTS button to change pres-
sure unit (psi, bar, MPa).
Continue to press DTS button to cycle from psi to bar to
MPa. Release DTS button to select units.
ti5802a
ti5804a
ti13760a
ti13761a
ti13762a
psi
bar
MPa
psi
ti6225a