Graco SDP5 Marine Instruments User Manual


 
Service
312865R 31
6. Remove two screws (D) holding reed switch board
to the cover plate (F
IG. 34). Keep these screws for
reassembly. Remove cover assembly.
7. Remove and discard o-ring (5) (F
IG. 35).
8. Remove guard (9) by inserting your thumb or finger
behind the cover and pry it loose. Then slide guard
down and out of groove on housing (F
IG. 36).
9. Unscrew solenoid (12) and remove from meter
housing (F
IG. 37). If necessary, a pliers can be used
to loosen solenoid.
F
IG. 34
F
IG. 35
ti11940a
D
5
ti11941a
FIG. 36
F
IG. 37
9
ti12009a
12
ti12238a