Filter
Top Products
Multimeter Command Reference 135Chapter 3
FRESistance:RESolution
[SENSe:]FRESistance:RESolution <resolution> selects the resolution for 4-wire
resistance measurements.
Parameters
Comments • MINimum selects the best resolution (the smallest value) for the selected range.
MAXimum selects the worst resolution (the largest value) for the selected
range.
• You must select a range using FRESistance:RANGe before specifying
resolution. Also, only specify a resolution when making measurements on a
fixed range. Otherwise, the resolution will change to correspond with the range
selected during autoranging.
• Specify resolution in the same units as the measurement function.
• If autoranging is required, set the resolution using the MIN or MAX parameters
or select a specific integration time using
FRESistance:NPLCycles.
• *RST Condition: FRES:RES 1m
Ω
(1E-03)
FRESistance:RESolution?
[SENSe:]FRESistance:RESolution? [MIN|MAX] returns one of the following
numbers to the output buffer:
• The present resolution selected if MIN or MAX are not specified. Only the
resolution values available on ranges set by the
RANGe command are
returned.
• The resolution with the smallest value (i.e., the best resolution) for the selected
range if
MIN is specified.
• The resolution with the largest value (i.e., the worst resolution) for the selected
range if
MAX is specified.
Example Query the Resolution
FRES:RES 0.3E-03
Set resolution to 0.3m
Ω
.
FRES:RES?
Query multimeter to return the present
resolution.
enter statement
Enter value into computer.
Parameter Name Parameter Type Range of Values Default Units
<
resolution>
numeric
resolution|MIN|MAX
ohms