Filter
Top Products
RUDDER & TILLER SYSTEM
i
.
~@
ii";,,,,"
.,
,,~
"~~
FIGURE 14 FIGURE 15
Install the left rudder assembly onto the transom of Install the drain plugs into their housings in each
the left hull. The nylon nuts will be facing inboard. transom. Make sure that the a-ring gaskets are pro-
With the tiller arm held out of the way, slip the rudder perly in place.
pin - cotter key up - down through the casting and
gudgeons. Once in place, install the other cotter key
into the rudder pin below the casting (see Fig. 15).
Repeat with right rudder.
U
~
r ~
~
@
~
@ FIGURE 16 FIGURE 17
The illustration shows an exploded view of the tiller Tighten the nuts until the bolts protrude about two
connector kit. Notice that it depicts the port (left) thread widths beyond the nylon locking elements of
side. Install the tiller crossbar with the "PORT" sticker the nuts.
to the left side of the boat. 7