Filter
Top Products
2 - 2
Step 2. Charge the Batteries
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-
Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
Dolphin 6100s ship with both the main battery pack
and internal backup battery significantly
discharged of power. Charge the main battery
pack with the Dolphin charging cable until the LED
turns green (red while charging). The average
charge time for a fully depleted main battery is
5 1/2 hours. It takes less time if the battery has
some charge.
1. Attach the appropriate plug adapter to the
plug of the power cable.*
2. Insert the plug into the appropriate power
source.
3. Plug the Dolphin power cable into the DC
Power Jack (see page 3-11) on the bottom
end of the unit.
Note: If you remove the battery pack or it completely
discharges, there is a 30 minute window in which
to insert a charged battery pack before the
backup battery completely discharges. If your
backup battery completely discharges, the
contents of the RAM memory will be lost. If your
backup battery is less than fully charged, there is
a proportionally smaller window of time available.
LED Indicators
*This power cable can also be used to power the
Dolphin 6100 while in the Dolphin HomeBase/
eBase Device (see page 10-1).
Red LED On
Charging
Green LED On
Battery is fully charged
1
2
3
!
!
!