Filter
Top Products
POWER, as previously discussed, powers the Wide W for normal operation. Also, if the unit is
powered off, press and hold POWER until you hear a continuous “chirp” to enable simulator
operation, as discussed in “Simulator Operation”. Pressing POWER when the unit is in normal or
simulator operation will power the unit off.
STOP freezes the display to allow closer study. Pressing STOP again will resume normal
operation. Also if a menu is on-screen until STOP is pressed again.
LIGHT enables a two-level display back light. Pressing once will turn the light on low, pressing a
second time will increase the back light to the high setting, and pressing a third time will turn the
back light off.
The four remaining buttons work together to control the Menu System- an array of menu
controlled functions.
Menu brings a menu on-screen for adjustment, or if a menu is already present, the next menu in
sequence will appear. Menus will go off-screen and normal operation will resume after a short
period of time. If you wish to keep the menu on-screen for an extended period of time, press
STOP.
UP arrow selects the next larger or next sequential adjustment within the menu. Holding an
Arrow button down will cause the unit to continue to make the adjustment, until a limit is reached,
and the limit alarm sounds.
DOWN arrow selects the next smaller adjustment within the menu.
ENTER is used to toggle other menu options on and off.
All menus use the same general layout as shown in the sample men at the right. The heading of
the menu is at the top. The area in the center is controlled by the UP and DOWN arrows, and the
area under the horizontal line is controlled by the ENTER button. Not all menus are affected by all
controls, but the layout is the same regardless. Pressing MENU repeatedly will sequentially
display all available menus.
MENU FUNCTIONS