Filter
Top Products
14
4
MEMORY OPERATION
■ Memory names
ïProgramming memory names
The memory channel can display a 6-character comment as
well as a frequency.
q Rotate the [DIAL] to select the desired frequency in Fre-
quency mode.
w Push
,
then push [MR].
e Rotate the [DIAL] to select the desired memory channel to
be programmed.
•Push [BANK] to select the BANK number if desired. Push [CLR]
to exit the BANK selection mode.
r Push [MR] to enter the memory name programming mode.
•“-- -- -- -- -- -- ” appears on the display.
t Push the appropriate digit key several times to select the
desired character as listed at right.
•To erase a character, overwrite with a space (displayed as _).
•To move the cursor forwards or backwards, use [DIAL].
y Push [ENT] to program the name.
•Flashing stops.
•When no name is programmed, the display shows the operating
frequency.
•To clear the entered comment, push [CLR] before pushing [ENT].
key Character
1 1, Q, Z
4 4, G, H, I
7 7, P, R, S
ENT Program
key Character
2 2, A, B, C
5 5, J, K, L
8 8, T, U, V
0 0, space –
key Character
3 3, D, E, F
6 6, M, N, O
9 9, W, X, Y
ïClearing memory contents
Unwanted memory channels can be cleared. Programming
over a memory channel also clears the previously pro-
grammed contents. Memory channel 1 cannot be cleared.
q Select the memory channel to be cleared.
w Push
,
then push and hold [CLR] for 1 sec.
•“-- -- -- -- -- --” appears momentarily, then the next selec-
table channel appears.