Filter
Top Products
9
2
PANEL DESCRIPTION
2
CALL KEYS “
CCAALLLL
” “
CCAALLAA
” “
CCAALLBB
”
Push to transmit a 2-tone.
•Call transmission is necessary before you call another station
depending on your signaling system.
•[Call A] and/or [Call B] may be available when your system employs
selective ‘Individual/Group’ calls. Ask your dealer which call is
assigned to each key.
EMERGENCY KEY “
EEMMRR
”
Push and hold for a specified period to transmit an emer-
gency call.
• If you want to cancel the emergency call, push (or push and hold)
the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code depending on the pre-setting.
SURVEILLANCE KEY “
SSUURRVV
”
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE CHANNEL SELECT KEY “
TTXXCC
”
➥Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
((☞ p. 15))
TX CODE CHANNEL UP/DOWN KEYS “
TTXXCCUU
” “
TTXXCCDD
”
Push to select a TX code channel directly.
SCRAMBLER FUNCTION “
SSCCRR
”
Push to toggle the voice scrambler function ON and OFF.
COMPANDER KEY “
CCOOMMPP
”
Push to toggle the compander function ON and OFF.
The compander function reduces noise components from the
transmitting audio to provide clear communication.
PHONE KEY “
PPHHNN
”
Push to connect or disconnect the telephone network con-
nection during LTR operation.
USER SET MODE KEY “
SSEETT
”
➥Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and
change the value or condition using push [CH Up]/[CH Down].
➥Push and hold this key again to exit user set mode.
User set mode is also available via the ‘Power ON function.’
Refer to ((☞ p. 16)) also.
OPT OUT KEYS “
OOPP11
” “
OOPP22
” “
OOPP33
”
Push to control the output signal level of the optional ports in
the optional unit connector.
OPT MOMENTARY KEYS “
OO11MM
” “
OO22MM
” “
OO33MM
”
Push and hold to control the output signal level of the option-
al ports in the optional unit connector.