Filter
Top Products
11
3
FREQUENCY SETTING
■ Read me first
The IC-R8500 uses memory channels for storage of
frequencies (as well as mode, tuning steps, etc.).
When turning power OFF or changing memory chan-
nels, the previously displayed frequency cannot be
recalled unless it has been stored into a memory
channel. Therefore, when you want to keep a dis-
played frequency for later recall, you must program it
into a memory channel by pushing [MW] for 1 sec.
✔
Convenient:
Use [M-SET] to program a displayed frequency (and
its mode, etc.) without overwriting the currently select-
ed memory. See p. 19.
■ Using the keypad
➀Push the numeral keys on the keypad to enter the
MHz digits for the desired frequency.
•If a key is mistakenly pushed, push [CE
s
] and start
again from the beginning.
•When entering the same MHz digits as the displayed
frequency, this step can be skipped.
➁Push [
•
t
].
➂Push the numeral keys to enter the frequency digits
below 1 MHz.
•If a key is mistakenly pushed, push [CE
s
] and start
again from the beginning.
➃Push [ENT] to set the input frequency.
•When pushing [ENT] after entering the MHz digits, zeros
are automatically entered for the kHz digits.
[EXAMPLE]: SETTING THE FREQUENCY USING THE KEYPAD
• To set to 145.00 MHz
1
45
ENT
• To set to 1296.040 MHz
1
296
•
04
ENT
• To set to 850 kHz
(0.85 MHz)
08
5
•
ENT
• To change from 1296.040
to 1296.850 MHz
8
5
•
ENT
Push [MW] for 1 sec. after tuning.
FM
OFF
kHz
DLY
∞
USR-A BLANK
“BLANK” appears in the memory name area until
[MW] is pushed for 1 sec.