Filter
Top Products
55
12
CLONING
Cloning allows you to quickly and easily transfer the programmed
contents from one transceiver to another transceiver; or, data from
a PC to a transceiver using the optional CS-V8
CLONING SOFTWARE
.
D Transceiver-to-transceiver cloning
q Connect the OPC-474
CLONING CABLE
with
adaptor plugs to the [SP] jack of the master and sub-trans-
ceivers.
• The master transceiver is used to send data to the sub-transceiver.
w While pushing [A•
FUNC
]+[Y], turn power ON to enter cloning
mode (master transceiver only— power ON only for sub-trans-
ceiver).
• “CLONE” appears and the transceivers enter the clone standby
condition.
e Push [PTT] on the master transceiver.
• “CL” appears in the master transceiver’s display and two digit num-
bers show that data is being transferred to the sub-transceiver.
• “CL IN
” appears automatically in the sub-transceiver’s display and
two digit numbers show that data is being received from the master
transceiver.
r
When cloning is finished, turn power OFF, then ON again to exit
cloning mode.
D Cloning using a PC
Please refer to the HELP file that comes with CS-V8
CLONING
SOFTWARE
.
NOTE: DO NOT push the [PTT] on the sub-transceiver during
cloning. This will cause a cloning error.
AT
POWER ON