Filter
Top Products
30
SET MODE
New2001
8
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: Scan type (Normal or Priority,) Scan re-
sume timer, Weather alert, Dual/Tri-watch, DSC watch, Beep
tone (transceiver,) LCD contrast and Auto ACK.
Available functions may differ depending on dealer setting.
D Set mode operation
q Turn power OFF.
w While pushing [16•
9], turn power ON to enter Set mode.
• “” appears at the channel comment indicator.
e After the display appears, release [16•9].
r Push [16•
9] to select the desired item, if necessary.
t Push [Y] or [Z] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
D SET MODE CONSTRUCTION
Beep tone LCD contrast
Starting item
Scan type Scan resume timer Weather alert
Dual/Tri-watch DSC watch
Auto acknowledgement
Push
Scrolls
Scrolls
!IC-M402A_SA.qxd 03.11.11 2:52 PM Page 30 (1,1)