Filter
Top Products
8A-4 - POWER STEERING PUMP 90-823226--1 996
Important Service
Information
Pump Pulley Replacement
REMOVAL
IMPORTANT: Kent-Moore Tool J-25034 must be
used to remove the pressed-on pulleys used on
power steering pumps. This tool has an end on it
that will not mushroom the end of the pump shaft.
DO NOT use Kent-Moore Tool J-21239 to remove
these pulleys. This tool has a tapered end and will
damage the shaft.
1. Install Kent-Moore Tool J-25034 on end of pulley
and shaft as shown.
2. While holding tool with suitable wrench, turn
threaded screw until pulley is removed.
72821
a
a - Kent-Moore Pulley Removal Tool (J-25034)
INSTALLATION
Install pulley, as follows, using pulley installer tool
(91-93656A1), and a long straight edge:
1. Place pulley on pump shaft.
2. Thread stud all the way into pump shaft. Place
bearing over stud. Do not use spacer from kit.
3. Thread nut onto shaft. Thread tool shaft (and nut)
all the way onto stud (threaded into pump pulley).
4. Using a long straight edge (to check drive belt
alignment), turn large pusher nut until drive belt
is parallel to straight edge.
5. Check pulley installation for correct alignment.
72822
b
c
d
e
f
g
h
i
a
a - Power Steering Pump Pulley
b - Stud
c - Do Not Use Spacer
d - Bearing
e - Nut
f - Tool Shaft
g - Crankshaft Pulley (shown) Or Water Circulating Pump
Pulley
h - Long Straight Edge
i - Drive Belt Parallel
Index