Filter
Top Products
14
receiving
1 Select the desired zone and channel using the GRP and keys and the
CH control.
2 When you hear a caller’s voice, readjust the volume as necessary.
• If signaling has been programmed on the selected channel, you will hear a call only
if the signal tone matches the tone set up on your transceiver.
Note: Signaling allows your transceiver to code your calls. This will prevent you from listening
to unwanted calls. It does not make calls private, it only prevents them from being heard by
transceivers set with a different signaling code. Refer to “SIGNALING” on page 28 for details.
■ Receiving Group Calls (P25)
When you receive a group call on a Conventional channel and the received
group ID matches the ID set up on your transceiver, you can hear the caller’s
voice.
When you receive a group call on a Trunking channel, the transceiver
automatically switches to the traffic channel to receive the call.
• Readjust the volume as necessary.
■ Receiving Individual Calls (P25)
When you receive an individual call on a Conventional channel, a ringing tone
will sound and the display will show the caller’s ID. To respond to the call,
press and hold the microphone PTT switch and speak into the transceiver as
you would during a normal transmission.
When you receive an individual call on a Trunking channel, a ringing tone will
wound and the display will alternate between the caller’s ID and “RECEIVING”.
To receive the call, press the PTT switch. To deny the call, press and hold the
PF 1 key or the DTMF # key. After receiving the call, you can respond to the
call by pressing and holding the PTT switch and speaking into the microphone
as you would during a normal transmission. After the call is finished, press the
PF 1 key or the DTMF # key to end the call.