Filter
Top Products
32
• Display Character
Press this key to switch the display between the zone and channel number and
the zone and channel name (if names have been programmed).
• Emergency
Refer to “EMERGENCY CALLS” on page 25.
• External Speaker
Press this key to switch the speaker from the transceiver’s built-in speaker to an
optional external speaker. When using an external speaker, the
(KCH-14) or
SP
(KCH-15) icon appears on the display.
• Function
Press this key, then press a programmable key to activate its secondary function.
• GPS Position Display
Press this key when the GPS unit has been installed to display your location data.
• Home Channel
Press this key to jump to your home zone and channel (pre-programmed by your
dealer). If activated by your dealer, you can set your own Home Channel by
selecting your desired zone and channel, then pressing and holding the Home
Channel key for 3 seconds.
• Horn Alert
Press this key to toggle the Horn Alert function ON and OFF. “HORN ALERT”
appears on the display when Horn Alert is activated. When a call is received that
has a correct DTMF code or 2-tone signaling, Horn Alert causes the vehicle horn
or some other external alert to sound.
• Individual
Refer to “Making Individual Calls (P25)” on page 13.
• Intercom
Press this key to toggle the Intercom function ON and OFF. “INTERCOM” appears
on the display when Intercom is activated. To use the Intercom function, your dealer
must first install a dual-head (microphone and speaker) system. When making a
call, your voice will be transmitted over the speaker system.
• Key Delete
Refer to “Deleting the encRyPtiOn key” on page 27.
• Keyset
Press this key to change the Keyset stored in a Secure Cryptographic Module
(SCM).
• LCD Brightness
Press this key to change the brightness level of the LCD. Each time this key is
pressed, the brightness levels cycle as follows:
High Mid Low Off
• Monitor
Press this key to turn the transceiver signaling off, to listen to all calls that are
received on the channel. While monitor is activated, the (KCH-14) or
MON
(KCH-15) icon appears on the display. Press the Monitor key again to turn the
transceiver signaling back on.
Press and hold this key for 2 seconds to turn the transceiver squelch off, to listen