Filter
Top Products
17
ScAn progrAmming <TK-5710/ TK-5710h/ TK-5810/ TK-5810h only>
Note: Scan programming is only available when using Conventional operation.
■ Conventional Operation
If Scan Type has been programmed for Conventional operation, you are able
to reprogram your scan list.
1 Press the key programmed as Scan Program.
• The (KCH-14 ) or
SCAN
(KCH-15) icon appears on the display and blinks.
2 Press the GRP and keys or rotate the CH control to select the zone
and channel you will add to or remove from the Scan list.
• Press the PF 2 key to toggle between Zone Select and Channel Select.
3 Press the PF 4 key to add or remove the selected zone or channel to/ from
the scan list.
• The zone add indicator (KCH-14: / KCH-15: )/
channel add indicator (KCH-14:
/ KCH-15: ) will
appear on the display when the selected channel is added to the scan sequence.
4 Press the PF 1 key to exit scan programming.
If the Priority channel has been set as Operator Selectable by your dealer, you
are able to reprogram the Priority mode as well.
1 Press the key programmed as Scan Program.
• The (KCH-14) or
SCAN
(KCH-15) icon appears on the display and blinks.
2 Press and hold the PF 3 key to edit the Priority channel.
3 Press the GRP and keys or rotate the CH control to select the
channel you will set or unset as Priority.
4 Press the PF 4 key to toggle the selected channel between Priority and
Normal.
• “P1”, “P2”, or “PP” appears on the sub-display when Priority mode is selected.
5 Press the PF 3 key again to set the new channel setting.
6 Press the PF 1 key to exit scan programming.