Filter
Top Products
22
MENU SETUP
WHAT IS A MENU?
Many functions on this transceiver are selected or
configured via a software-controlled Menu, rather
than through the physical controls of the transceiver.
Once familiar with the Menu system, you will
appreciate the versatility it offers. You can customize
the various timings, settings, and programming
functions on this transceiver to meet your needs
without using many controls and switches.
MENU A/ MENU B
This transceiver has 2 menus: Menu A and Menu B.
These menus contain identical functions and can be
configured independently. The transceiver, therefore,
allows you to switch between 2 different
environments quickly and easily. For example, you
can configure Menu A for DXing and contesting while
Menu B is for relaxed local ragchewing. By switching
from Menu A to Menu B, you can instantly change the
Menu configuration and key assignment to suit your
current operating style. Or, 2 operators may share a
single transceiver by dedicating one Menu to each
operator. Both operators can always enjoy their own
configuration.
MENU ACCESS
1 Press [MENU/ F.LOCK].
• The Menu No. and setting appear on the
display, and the explanation of the menu
appears on the sub-display.
2 Press [A/B / M/V] to select Menu A or Menu B.
•“A” or “B” appears, indicating which Menu is
selected.
3 Turn the MULTI control to select the desired Menu
No.
• Each time you change the Menu No.,
a different scrolling message appears on the
sub-display, describing the Menu No.
4 Press [ ]/ [ ], or Mic [UP]/ [DWN] to select a
parameter.
5 Press [MENU/ F.LOCK] to exit Menu mode.
QUICK MENU
Because the number of functions this transceiver
provides is extraordinary, there are numerous items in
each Menu. If you find accessing desired Menu Nos.
to be too time consuming, use the Quick Menu to
create your own customized, abbreviated Menu. You
can then add those Menu Nos. which you frequently
use, to the Quick Menu. Copying Menu Nos. to the
Quick Menu has no effect on the Menu.
PROGRAMMING THE QUICK MENU
1 Press [MENU/ F.LOCK].
2 Turn the MULTI control to select the desired Menu
No.
3 Press [QMI/ M.IN].
• An inverted star, “ ” appears, indicating that
the Menu item has been added to the Quick
Menu.
• To remove the item from the Quick Menu,
press [QMI/ M.IN] again. “ ” disappears.
4 Press [MENU/ F.LOCK] to exit Menu mode.
USING THE QUICK MENU
1 Press [MENU/ F.LOCK].
2 Press [MHz].
•“MHz” appears.
3 Turn the MULTI control to select the desired Quick
Menu No.
4 Press [ ]/ [ ], or Mic [UP]/ [DWN] to change the
current setting for the selected Menu No.
• When the Menu is registered to the Quick
Menu list, “ ” appears.
5 Press [MENU/ F.LOCK] to exit Quick Menu mode.
Note:
If the Quick Menu has not been programmed, turning the
MULTI
control in step
2
causes “CHECK” to be output in Morse code.