Filter
Top Products
68
13 OPERATOR CONVENIENCES
CONTROLLING THE TS-480 FROM PC
If a PC and the TS-480HX/ SAT are connected using
a serial cable {page 76}, you can remotely control the
functions of the TS-480 from a PC. Download the
free ARCP-480 software from the following URL.
http://www.kenwood.com/i/products/info/amateur.html
The detailed remote controlling instructions are
available in accompanied documents and help file.
REMOTE CONTROLLING THE TS-480 ON THE
NETWORK
In addition to the ARCP-480 program, the ARHP-10
program can also be downloaded from the above
site. This ARHP-10 program is a ARCP-480 host
program that allows a user who is connected in the
network to remote control the TS-480 transceiver
from a distant location. If you make interface cables
that transfer the audio between the TS-480
transceiver and PC on the host transceiver, you can
receive signals and transmit your voice over the
network. For detailed information, download the
ARHP-10 program and consult accompanied
documents.
VGS-1 VOICE GUIDE & STORAGE UNIT
(OPTIONAL)
The optional VGS-1 unit allows you to record a
maximum of 30-second voice message to 3 different
memory channels. After recording a message via
your transceiver microphone, you can then transmit
those recorded messages. It also announces the key
function and frequencies each time you press a key
(Voice announcement). Since the incoming reception
signal is processed in digital data in the transceiver,
the VGS-1 can be configured to store the incoming
audio signals constantly in the background. If you
wish, you can store the last 30-second of the
incoming signal to the VGS-1 for the later playback
(Constant recording).
For information on how to install the VGS-1 unit, refer
to “INSTALLING OPTIONS” {page 81}.
RECORDING MESSAGES
This section explains how to record a single
message.
1 Select SSB, FM, or AM mode {page 19}.
• Select a mode that you wish to transmit.
2 If VOX is ON, press [VOX/ 8] to switch the
function OFF.
3 Press [CH1/ 1/ REC] (1 s) to record the message
for channel 1.
• BT in Morse code sounds and “AP1 –”
appears.
•To quit recording your message, press
[MTR/ CLR].
4 Press and hold [CH1/ 1/ REC], then begin
speaking into your microphone.
• Three channels are available for recording
messages. Press channel key [CH2/ 2/ REC]
or [CH3/ 3/ REC] in place of [CH1/ 1/ REC], in
step 3, to record the message on a different
channel.
• While the Constant Recording is working, CH3
is unavailable for the message recording.
5 Release the key pressed in step 4 when you have
finished recording your message.
• Also when the maximum recording time
passes, recording automatically stops.
• The contents of the channel is overwritten with
the new message.
• “FLASH WR” appears while the transceiver is
storing the message data to the VGS-1 flash
memory.
6 Repeat steps 3 to 5 to record a message on
another channel.
Note:
Pressing
[ ]
(POWER) cancels recording in progress and
clears the memory channel.