Filter
Top Products
78
14 CONNECTING PERIPHERAL EQUIPMENT
ANTENNA TUNER
Use the ANT 1 and AT connectors to connect an AT-300 external antenna tuner. If you connect the external
antenna tuner to the ANT 2 connector, it will not function.
Note:
When the AT-300 is used with the TS-480HX transceiver, the TX output power is automatically reduced to 100 W (AM mode: 25 W).
Also, the AT-300 cannot be used for 50 MHz operation.
DC
DC
13.8V
1
DC 2 13.8V
AT
GNDGND
GND
2
2
1
MCP AND TNC
Use the DATA connector to connect the AF input/ output lines from a Terminal Node Controller (TNC) for Packet
operation, a Multimode Communications Processor (MCP) for operation on AFSK, Packet, PacTOR, AMTOR,
G-TOR
TM
, PSK31, or FAX, or a Clover interface. Also use the DATA connector to connect SSTV and phone patch
equipment (1 male, 6-pin mini DIN connector (E57-0404-XX) is supplied).
• Connect the TNC or MCP to the DATA connector using a cable equipped with a 6-pin mini DIN plug.
• Connecting the TNC or MCP to a personal computer or dumb terminal requires an RS-232C cable.
• Select LSB or USB mode (it depends on the communication mode) when you operate the MCP/ TNC.
Note:
◆
Do not share a single power supply between the transceiver and the TNC or MCP. Keep as wide a separation as possible between the
transceiver and the computer to reduce noise-pickup by the transceiver.
◆
The mini DIN connectors (
REMOTE
and
DATA
connectors) look alike. Confirm the number of pins before plugging into the transceiver
connectors. The
DATA
connector is a 6-pin mini DIN connector and the
REMOTE
connector is an 8-pin mini DIN connector.
PADELE
KEY
EXT.SP
DATA
REMOTE
COM
MIC
PANEL
MCP/ TNC
Mini DIN male
(6-pin)
DC Power Supply
for the transceiver
Power Supply
for MCP/ TNC
DATA
q
w
e
r
t
y
DATA connector
(Front view)
.oNniP
niP
emaN
noitcnuF
1INACNT/PCMmorftupnioiduA
2GNAdnuorglangisoiduA
3STD
.timsnartotlanimretsihtdnuorG
eht,dednuorgsitinehW
.FFOsnruttupnienohporcim
4CNnoitcennocoN
5ONACNT/PCMroftuptuooiduA
6CQS
sutatshcleuqS
ecnadepmiwoL:nepohcleuqS•
ecnadepmihgiH:esolchcleuqS•
lateM
revoc
DNGdnuorG
DATA connector pin assignment (6-pin mini DIN)
ANT 1 connector