Kenwood TS-590S Marine Radio User Manual


  Open as PDF
of 92
 
2
,167$//$7,21
87,/,=,1*7+(%$,/
This transceiver is equipped with a bail so that you
can angle the transceiver. The bail is located on the
bottom of the transceiver. Pull the bail forward to the
limit as shown.
5(3/$&,1*)86(6
The following fuses are used in the TS-590S
transceiver. If a fuse blows, determine the cause
then correct the problem. Only after the problem has
been resolved, replace the blown fuse with a new
one with the specified ratings. If newly installed fuses
continue to blow, disconnect the power plug and
contact a Kenwood service center or your dealer for
assistance.
Fuse Location Fuse Current Rating
TS-590S Transceiver
4 A
(for external
antenna tuner)
Supplied DC power cable 25 A
Fuse (4 A)
Fuse (25 A)
Fuse (25 A)
$&&(6625<&211(&7,216
)52173$1(/
Q +HDGSKRQHV3+21(6
Connect monaural or stereo headphones with a
WRLPSHGDQFH7KLVMDFNDFFHSWVDPP
(1/4") diameter, 2-conductor (mono) or 3-conductor
(stereo) plug. After connecting the headphones,
you will hear no sound from the internal (or
optional external) Speaker/Microphone (MIC).
Q
0LFURSKRQH0,&
&RQQHFWDPLFURSKRQHZLWKDWR
impedance. Fully insert the connector, then
screw the retaining ring clockwise until secure.
Compatible microphones include the MC-43S,
0&0&'00&$0&0&DQG
MC-90.
Note: Do not use the MC-44, MC-44DM, MC-45, MC-45E,
MC-45DM, MC-45DME, or MC-53DM microphones.
5($53$1(/
Q ([WHUQDO6SHDNHU(;763
On the rear panel of the transceiver, there is an
external speaker jack. If an external speaker is
connected to EXP.SP, the transceiver internal
speaker will mute. Use only external speakers with
DQLPSHGDQFHRIWRQRPLQDO7KLVMDFN
accepts only 3.5 mm (1/8") diameter, 2-conductor
(mono) plugs.
Do not connect headphones to this jack. The high audio
output of this jack could damage your hearing.
Q .H\VIRU&:3$''/(DQG.(<
For CW operation while using the internal
electronic keyer, connect a keyer paddle to the
PADDLE jack.
For CW operation without using the internal
electronic keyer, connect a straight key,
semi-automatic key (bug), electronic keyer,
or the CW keyed output from a Multimode
Communications Processor (MCP) to the KEY
jack.
7KH3$''/(DQG.(<MDFNVPDWHZLWKDPP
(1/4") 3-conductor plug and a 3.5 mm (1/8")
2-conductor plug, respectively. External electronic
keyers or MCPs must use positive keying to be
compatible with this transceiver. Use a shielded
cable between the key and the transceiver.
Note: Due to the functionality of the internal electronic
keyer, you may find it unnecessary to connect both a paddle
and another type of keyer unless you want to use a
PC-based keyer for CW. Read the “ELECTRONIC KEYER”
section {page 33} to become familiar with the internal keyer.
 previous next