Filter
Top Products
9
6. Install and tighten four M10 x 25U (M10 x 1") mounting bolts. Use
anti-corrosive grease on each bolt to avoid difficulty in removing the
bolts later on.
7. Uncoil the scanner cable.
8. Secure the cable near the scanner to support the weight of the cable
and prevent strain on the watertight cable seal. If the cable is to pass
through tubing or a bulkhead, protect the unfinished end. Do not use
the unfinished wires or fabric braid to pull the cable. Attach a fish cord
only to the cable jacket.
Route the cable to the RIM 100 module’s location, securing it at appro-
priate points along the way. Make a drip loop and apply sealant at the
entry point of an exterior bulkhead.