Filter
Top Products
19
Aligning and Attaching the Transducer
Adjust the transducer so that its "face" is parallel with the ground and its center line is even
with the bottom of the boat hull.
Note: When mounting the transducer to the transom, there are two extremes you should
avoid, rst, do not let the edge of the mounting bracket extend below the bottom of the hull,
left image, above. Second, do not let the bottom of the transducer rise above the bottom of
the hull, right image, above.
The center line of the transducer
should be level with the bottom of
the boat hull and its "face" parallel
with the ground.
Transom
Bottom of hull.
Transducer face
For single frequency
transducers, with a
one-piece bracket,
assemble it with the
cable passing over the
bolt and through the
bracket, as shown here.
Do not over tighten
the transducer bracket
lock nut. If you do,
the transducer may not
"kick-up" if it strikes an
object in the water.
Transducer bracket
mounted too low.
Bottom of hull.Bottom of hull.
Transom Transom
Transducer bracket
mounted too high.