Filter
Top Products
27
2: Slip the clamp around the trolling motor, as shown
below. Tighten the hose clamp securely to
the trolling motor.
1: Slide the hose
clamp through the Pod
transducer brackets, as
shown below.
Hose
clamp
Hose
clamp
Cable ties Cable ties
Transducer
Pod Transducer Trolling Motor Installation
The top of the transducer is curved to t the contour of the trolling
motor.
You will need a hose clamp large enough to t over the
trolling motor. The hose clamp is NOT included with the Pod
transducer.
Before you attach the transducer to the trolling motor, make sure there is enough
slack in the transducer cable for the trolling motor to turn freely.
Note: The transducer should be mounted ahead of the trolling motor n. Position the
transducer to so its face is pointing straight down when the trolling motor is in the water.
Route the transducer cable along the trolling motor shaft. Use plastic ties (not included) to
secure the cable to the shaft.