Filter
Top Products
19
highlight the "Show Zoom Bar" on the
"Chart Setup" menu, then press the
right arrow key. Now press the EXIT
key. If you're not in the split-screen
mode, change to that mode. A screen
similar to the one at right appears.
To turn the zoom bar off, repeat the
above steps.
DISPLAY ZONE BAR
The zone alarm has a range bar. Any
echoes that appear between the top
and bottom of this bar triggers the
zone alarm. This bar normally doesn't
show on the screen. To turn the zone
bar on continuously, highlight the
"Show Zone Bar" on the "Chart Setup"
menu, then press the right arrow key.
Now press the EXIT key. A screen
similar to the one at right appears. To
turn the zone bar off, repeat the above
steps.
See the Alarms section in this manual
for more information on the zone alarm.
DIGITAL SONAR
When the X-65 is turned on, the digital depth display is located at the top
left corner of the screen. This display comes from a separate digital sonar
built into the unit. It displays only the bottom depth. If it loses the bottom,
the last known depth will flash on the display. When the digital finds the
bottom, it will automatically display the bottom depth again.
The digital sonar can be turned off, however this also turns all automatic
features off also, such as auto sensitivity, auto ranging, and the Fish ID.
feature.
To turn the digital off, first press the MENU key, then press the up or down
arrow keys until the "DIGITAL SONAR" menu appears. Press the left
arrow key to turn it off.
Note: Turning the digital sonar off also turns the automatic mode off,
including Fish ID, and the depth alarms.