Filter
Top Products
24
"Speaker" label, then press the left arrow key to turn it off.
System Information
This screen shows some basic data about the X-65. To view this, highlight
the "System Info" label on the System Setup menu, then press the right
arrow key. The system info screen appears. To erase this screen, press
the EXIT key. The X-65 returns to the System Setup menu.
Units of Measure
The X-65 normally shows the depth in
feet, speed in statute miles per hour,
distance in statute miles, and tem-
perature in degrees Fahrenheit. You
can change any of these settings us-
ing the units of measure menu. To do
this, highlight the "Units of Measure"
label on the System Setup menu, then
press the right arrow key. The screen
at right appears. Highlight the item
you want to change, then press the
right or left arrow key to change it. To
erase this screen, press the EXIT key.
Reset Distance Log
If you have a speed sensor attached to the X-65, the unit starts counting
the distance you've travelled each time you turn it on. You can reset this
distance to zero by turning the unit off and on again, however, it's easier
to highlight the "Reset Distance Log" label on the System Setup menu,
then press the right arrow key. This resets the log and keeps you in the
System Setup menu. To erase this menu, press the EXIT key.
Temperature Graph
Some of the X-65's screens have a temperature graph, as shown at right.
Normally, the temperature graph has a 2°
range. On the screen shown at right, the
temperature graph has a range from 72° to
74°. You can change this range to 4° or 10°
using the "Temp Graph" label on the System
Setup menu. Highlight that label, then press
the right arrow key until the desired tempera-
ture graph range is highlighted. Press the
EXIT key to erase the menu.