Filter
Top Products
BA-SERIES WALK-BEHIND TROWEL — OPERATION & PARTS MANUAL — REV. #2 (03/19/04) — PAGE 25
NEVER disable or disconnect the centrifugal Engine-Off
switch. It is provided for the operators’ safety and injury may
result if it is disabled, disconnected or improperly maintained.
3. Place the
centrifugal Engine-Off switch
(Figure 24) in the
"ON" position. For models that use this feature.
Figure 24. Centrifugal Engine-Off Switch
4. Place the
Choke Lever
(Figure 25) in the "
OPEN
" position
Figure 25. Engine Choke Lever
5. Grasp the starter grip (Figure 26) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 26. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 25) to the
CLOSED
position. If the engine has not
started repeat steps 1 through 5.
7.
Before the trowel is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard ring and/or covers.
8. To begin troweling, rotate the throttle (Figure 27) toward the
"
RUN
" position.
Figure 27. Throttle (Run Position)
BA-SERIES TROWEL — INITIAL START-UP
WARNINGWARNING
WARNINGWARNING
WARNING