Filter
Top Products
BA-SERIES WALK-BEHIND TROWEL — OPERATION & PARTS MANUAL — REV. #2 (03/19/04) — PAGE 35
BA-SERIES TROWEL — MAINTENANCE
Installing Pans Onto Finisher Blades
Refer to Figure 49 when installing pans onto finisher blades.
Figure 49. Pan Installation
1 BLADE ASSEMBLY
2 KNOB, TIE DOWN Z-CLIP PANS
3 TIED OWN, BLADE
4 Z-CLIP, PAN
3
2
4
1
1. Lower finisher onto pan with blades (item #1) adjacent to Z-
Clips (item #4).
2. Rotate blades into position under Z-Clips. Ensure that the
blades are rotated in the direction of travel when the machine
is in operation or use the engine to rotate the blades into
position.
3. Attach the blade tie-downs (item #3) to the far side of the Z-
Clip brackets (item #4) with tie-down knobs (item #2) as
shown in figure 49.
4. Check to make certain that the blade edges are secured
under the Z-Clips and the tie-downs are secured completely
over the edges of the blade bar before the machine is put back
into operation.
ALWAYS install pans either on the work area or on an area
that is next to and level with the work area. DO NOT lift the
trowel when the pans are attached.
WARNINGWARNING
WARNINGWARNING
WARNING