Filter
Top Products
LT12 SERIES LIGHT TOWER • OPERATION MANUAL — REV. #12 (01/20/09) — PAGE 7
SAFETY INFORMATION
NEVER remove safety pin or pull mast locking pin while
tower is in a raised position!
CHECK the mast and winch cables for wear. If any
problem occurs when lower or raising the tower,
STOP immediately! Contact a trained technician for
assistance.
NEVER pivot or retract mast while unit is operating.
NEVER use the light tower mast as a crane. DO NOT
lift anything with the mast.
NEVER attach anything to the light tower mast.
ALWAYS lower the light tower when not in use, or if high
winds or electrical storms are expected.
NOTICE
ALWAYS keep the immediate area surrounding the light
tower clean, neat, and free of debris.
ALWAYS keep the machine in proper running condition.
Fix damage to machine and replace any broken parts
immediately.
ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
To prevent the light tower from overturning, NEVER use
in winds that exceed 65 mph (105 kph).
LAMP SAFETY
WARNING
NEVER attempt to replace lamp with the power on.
Always shut down the engine or turn off circuit breakers
when changing the lamp.
ALWAYS allow a suffi cient amount of time for the lamp to
cool before touching or changing. The possibility exists of
severe burns.
CAUTION
NEVER use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
NEVER leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
ALWAYS make sure lamp surface is clean and dry.
ALWAYS replace with MQ recommended type lamp.
ALWAYS have a trained technician install and remove
a fl oodlight, or replace any damaged fi xture wiring.