Filter
Top Products
HTH-8 FT. RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (02/22/11) — PAGE 19
HTH — INITIAL START-UP
3. It is recommended that the kill switch be used to stop
the engine after every use. Doing this will verify that the
switch is working properly and presents no danger to the
operator. Remember to turn the key to the “OFF” position
after stopping the machine. Not doing so may drain your
units’ battery.
4. Place the engine throttle lever (Figure 7) in the LOW
position.
Figure 9. Oil and Charge Indicator Lights
Figure 8. Ignition Switch and Key
Figure 10. Engine Throttle Control Lever (High)
Figure 11. Left and Right Joystick Controls
Figure 7. Engine Throttle Control Lever (Low)
PRE
HEAT
CHARGE
WATER
OIL
ON FORAPPROXIMATELY5-10 SECONDS
WHEN IGNITIONSWITCH IS INTHE
PRE HEATPOSITION.
OILAND CHARGE INDICATOR LIGHTS
COME ONWHEN IGNITION SWITCH IS
IN THE POSITION.
5. Insert the ignition key into the ignition switch (Figure 8).
6. Turn the ignition key clockwise to the (start) position. The
oil and charge indicator lights (Figure 9) should be on.
NOTE
In cold weather turn the ignition key counter clockwise to the
preheat position, wait until the BLUE preheat indicator goes off
before turning the ignition key clockwise to the start position.
7. Turn ignition key fully clockwise and listen for engine to
start. Once engine has started release ignition key. Let
engine warm for a few minutes.
8. Place the engine throttle lever (Figure 10) in the HIGH
position.
9. The engine should be running at full RPM.
10. Repeat this section a few times to get fully acquainted
with the engine starting procedure.
Steering
Two joysticks (Figure 11) located to the left and right of the
operator’s seat provide directional control for the HTH Ride-
On Power Trowel. Table 3 (Page 15) illustrates the various
directional positions of the joysticks and their effect on the
ride-on trowel.
NOTE
All directional references with respect to the joysticks are from
the operator’s seat position.