Filter
Top Products
23
4
BIIS OPERATION
■ Transmitting a call
Total of a 3 ways for code selection are available—selecting the call
code from memory, entering the call code from the keypad and call-
ing back from the queue channel record.
DD
Using call memory
q While in the standby condition, push [P1] (Digital) to enter the
call code memory channel selection mode.
w Push [ ]/[ ] to select the desired call code.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
“”is
displayed during each call. However, an error beep sounds
and
“”
is displayed when no answer back is received
after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P3] (Moni(Audi)) to send the “Clear down” signal.
Call code text is displayed.
IC-F50_F60_MDC-2.qxd 06.11.17 4:39 PM Page 23 (1,1)