Filter
Top Products
40
5
MDC 1200 OPERATION
5
DD
Transmitting a Message
The transceiver can send a pre-programmed message to the dis-
patcher. There are 16 messages that can be sent on a channel.
qPush [MDC Call] to enter the MDC menu selection mode.
wSelect “MSG” using [CH Up], [CH Down], [MDC Up] or [MDC
Down].
ePush [MDC Call] again to enter the pre-programmed message
selection mode.
rSelect the desired message using [CH Up], [CH Down], [MDC
Up] or [MDC Down].
tPush [PTT] to transmit the message to the dispatcher.
• “MSG TX” is displayed.
yRelease [PTT].
• “MSG OK” is displayed.
• “MSG FAIL” is displayed if there is no acknowledgment from the
dispatcher.
uAfter a specified time period has passed, the transceiver will re-
turn to receive.
Pre-programmed message is displayed.
IC-F50_F60_MDC-2.qxd 06.11.17 4:39 PM Page 40 (1,1)