Filter
Top Products
Usage Below Freezing
When the temperature is below freezing, a fully discharged cylinder may
not adequately inflate your Inflatable PFD. Under these conditions use
the oral inflator to adequately top-up the PFD.
WARNING: CO
2
inflation could over-pressurize and damage your
Inflatable PFD if already orally inflated.
Re-arming Your PFD (MD3081 and MD3082)
NOTE: A re-arm kit (MA7203) is required for this procedure.
IMPORTANT: Follow instructions in the exact sequence below.
1) Unpack or open the Inflatable PFD so that the manual inflator is
exposed (Fig. 8).
2) Remove the cylinder/bayonet assembly by rotating counter-clockwise
and then pull out. Discard the used cylinder/bayonet assembly.
3) Check the new cylinder/bayonet assembly to ensure the o-ring is in
place and the sensor ring is attached (Fig. 8). Ensure that the CO
2
cylinder has not been pierced (Fig. 11).
Inflatable PFD Owner’s Manual 8