Filter
Top Products
Defining WLAN connection settings
7
Copyright © 2005 Nokia. All rights reserved.
A WPA pre-shared key needs to be at least 8
characters long..
Press Next to proceed. If you do not need to configure
any advanced settings, press Finish to save the settings
of your new IAP. Otherwise, press Advanced.
Note: If you selected the 802.1x or the
WPA/EAP security mode, you have to access
the advanced settings to configure EAP
settings.
4 In the advanced settings, press Menu to change to the
802.1x page (in 802.1x mode) or WPA page (in WPA
mode), and make sure that the WPA mode is set to EAP,
as it should by default. This means that EAP based
logon will be used.
Press Menu again to change to the EAP page and
configure the EAP settings. Select the EAP methods
that are allowed in this mode by moving up and down
in the list and pressing Disable or Enable. Typically, the
user uses only one EAP method, so in most cases only
one EAP method should be enabled in this dialog.
5 In the advanced settings, press Menu to change to the
IP configuration page and set the IP address and
parameters, if necessary. In public wireless LAN
networks DHCP is typically used, so the default value
Yes for Auto retrieve IP should be used there. For the
IPv6 DNS mode, you can select one of three
alternatives: DHCP, Manual or Well known. If you select
Manual, you need to type the IP addresses of the
primary and secondary DNS servers.
6 In the advanced settings, press Menu to change to the
Proxies page and configure the HTTP and HTTPS proxy
settings, if necessary. If a web proxy needs to be used,
select the protocol (HTTP or HTTPS), set User proxy
server to Yes, type the IP address or domain name of
the Proxy Server, type the Port Number (for example
8000 or 8080). You can use the No proxy for field to
define the domains for which the HTTP or HTTPS proxy
is not needed.
7 Press Done and press Finish to save the settings of
your new IAP.
Nokia_9500_Using_WLAN_en_1.fm Page 7 Friday, December 9, 2005 1:08 PM