Filter
Top Products
C2943M (1/08) 13
t MENU/EXIT: Displays or exits the on-screen menu.
u KEY LOCK: Locks the buttons to prevent unauthorized operation of the equipment.
~í ("/VOL- and !/VOL+, # , and $): Controls the cursor on the on-screen menu and adjusts the volume up or down.
~â ENTER: Confirms (store or enter) your choice in the on-screen menu.
~ä SCAN: Changes the screen’s scan mode (Under, Full, Over, 4:3). (The 4:3 mode applies only to the 26-inch model.)
~ã STILL: Freezes the current picture.
~å MEDIA MENU: Displays or exits the media menu.
~ç PLAY/PAUSE: Play and pause the slide show picture or video clip.
~é STOP/RTN: Stop the slide show, or return to the previous page or video clip.
~è ("/ !/ #/ $/ ): Controls the cursor on the media menu.
When viewing pictures, the left and right arrow buttons (" and !) select the previous or next picture. The up and down arrow buttons
(# and $) rotate the picture.
However, with sound turned on, the up and down arrow buttons (# and $) increase or decrease the sound. The left and right arrow buttons
(" and !) have no function.
OSD FUNCTION
INPUT SOURCE DISPLAY
Figure 6. Input Source Display Screen
The input source is displayed in the upper-right corner, where it can be changed. It can be changed using the Source button on the monitor or
using the buttons on the remote controller (when the OSD Mode Label is set to ON. The default setting is OFF.)
To use the menus, do the following:
1. Press the MENU button to access the Main menu.
2. Use the up and down arrow buttons (# and $) to highlight a selection.
3. Press ENTER to select an item.
4. Use the up and down arrow buttons (# and $) to highlight a selection.
5. Use the "/VOL- and !/VOL+ arrow buttons to adjust the setting of a selected item.
VIDEO 1
VIDEO1
VIDEO2
CAMERA
MEDIA