22 C2943M (1/08)
CAMERA INSTALLATION AND CAMERA ADJUSTMENT
1. Plug the two camera connection leads from inside the monitor into the connectors on the camera.
2. Attach the camera using three spacers and three screws (14 mm). Do NOT overtighten the screws or the spacers will collapse. The focus
knobs need to be positioned as shown in Figure 14 on page 22.
3. Tuck the camera leads neatly into the monitor.
4. Verify the video on the monitor. If satisfactory, close the door. Hand-tighten the thumbscrew. If unsatisfactory, go to step 5.
5. The camera focus and zoom come from the factory with a medium setting. They can be adjusted with the built-in camera located inside the
monitor. Refer to Figure 14 on page 22.
To adjust the camera zoom, adjust the zoom and lightly tighten the focus knob.
Figure 14. Adjusting the Camera
6. Close the door and hand-tighten the door thumbscrew.