C2943M (1/08) 17
PIR Input: Sets the video input that displays when motion is detected. Select VIDEO 1, VIDEO 2, or CAMERA.
PIR Dwell: Sets the length of time a selected video source triggered by motion detection displays on the screen (5 to 20 seconds).
CYCLE SETUP
Cycle: Sets the cycle of the input source: OFF, FULL, PIP, or PBP. The settings OFF and FULL are only available if PIR Mode is set to PIP or PBP.
Video1 Cycle Time: Sets the cycle time of Video 1 (OFF, 5 to 30 seconds).
Video2 Cycle Time: Sets the cycle time of Video 2 (OFF, 5 to 30 seconds).
Camera Cycle Time: Sets the cycle time of Camera (OFF, 5 to 30 seconds).
Media Cycle Time: Sets the cycle time of Media (OFF, 5 to 30 seconds). When this feature is set to OFF, the cycle will skip the input.
CAMERA
This menu displays when there is camera input.
SYSTEM: Select NTSC or PAL.
ASPECT: Select 4:3 or 16:9.
SCAN: Select Progressive or Interlace mode.
MIRROR: Sets the camera image to be flipped horizontally (ON or OFF).
MAINTENANCE
ISM: Image sticking minimization (ISM) reduces “sticking” or retention of an image that displays for a long period time.
If selected, the ISM function starts 10 minutes after the PVM enters “sleep mode” through the light sensor setting.
NOTE: The panel backlight is not lit during this operation.
The operation period can be set from 1 to 8 hours.
Once the function begins, wait for the period you selected to end before normal operation resumes. If necessary, you can end the ISM function by
returning the environment light back to normal intensity, which “wakes up” the PVM. A second method would be to cycle power to the unit using
the remote control, the power button on the side of the unit, or the power source.
Default: Select Default to return to the default settings (refer to Figure 8 on page 15); default settings are boldface.