Filter
Top Products
12 C1649M (1/06)
NOTE: The WM5001 wall mount kits can be used with the WM5002 wall mount kits, which are
designed for mounting of double-width fiber optic modules. If mounting a mix of single-width
and double-width modules is desired, it is recommended that a maximum of two single-width
modules and one double-width module be mounted in combination with one another.
For mounting instructions using the wall mount kits, refer to the WM5000 Series Wall Mount
Kit Installation manual.
Mounting the FR8302A Receiver Using the Wall Clip
NOTE: Before mounting the FR8302A receiver to a wall, ensure that there is adequate space at both
ends for viewing the front-panel LEDs and for making the various rear-panel cable connections.
To attach the FR8302A receiver to a wall using the supplied wall clip, refer to Figure 4 and do the
following:
1. Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using
two screws (not provided).
2. Slide the module into the clip until the two holes on the bottom of the module align with the
two holes on the lower flange of the clip.
3. Attach the module to the clip using the two Phillips pan head screws provided for the clip.
Figure 4. Mounting the FR8302A Receiver to a Wall Using the Wall Clip
WALL CLIP
SCREW, PHILLIPS
PAN HEAD WITH
LOCK WASHER (2)
LOWER
FLANGE
HORIZONTAL
MOUNTING HOLE (2)
VERTICAL
MOUNTING HOLE (2)
UPPER
FLANGE