Filter
Top Products
49
Slide the setting switch back up to the (white
dot).
When you turn the camera on and press the
shutter release button halfway down, the
channel is registered on the camera.
Next, set the channel of the separated (wireless)
flash unit to the same channel as the flash unit
attached to the camera.
Place the other AF540FGZ in the desired
position.
Set the power switch of the flash unit to
(WIRELESS).
Press the wireless mode button (M/C/S) the
number of times required to display SLAVE on
the LCD panel.
Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
Press the channel button (CH) and select the
same channel that the flash unit attached to
the camera has been set to.
Slide the setting switch back up to the (white
dot).
● The two flash units must be set to the same
channel, otherwise the separated flash unit will
not discharge.
Set the sync mode switch of the wireless flash
unit to leading curtain sync ( ).
Set the exposure mode of the camera to manual
exposure and the shutter speed faster than X-
sync speed.
● If the shutter speed is the same or slower than
the X-sync speed of the camera, the flash will be
set to P-TTL mode, and when it is faster than X-
sync speed, the flash will be set to high-speed
sync mode.
Confirm that both flash units are fully charged,
and take the photograph.
A lamp on the wireless flash unit will blink.
2
3
4
5