Filter
Top Products
32
FEATURES AND CONTROLS
New Generation Instrument (NGI)
Instrument Operation
DISPLAY MODE
There are three different display modes the gauge uses
to display information to the operator. The three
modes are: MAIN MODE, SPEED/TACHOMETER
MODE and NAVIGATION MODE. Press and release
the MODE button on the left handlebar control to
advance through the three modes.
MAIN MODE displays SPEED and CLOCK.
SPEED/TACHOMETER MODE displays SPEED
and TACHOMETER.
NAVIGATION MODE displays SPEED, TRIP
ODOMETER and ENGINE HOURS.
CLOCK SET
In the main mode, press and hold the RESET button
until the hour digits flash (approximately six seconds).
Press the RESET button to advance the hour digits.
Press the MODE button to stop the hour flash and
begin the minute digits flash. Press the RESET button
to advance one minute. Press the MODE button to set
the clock and exit the clock set mode.
TRIP ODOMETER RESET
Press and hold the RESET button until the trip
odometer is reset to 000.0 miles / km.
CHANGE UNITS OF MEASURE
To toggle between English and metric units of
measure, press and hold the MODE button for ten
seconds.