Filter
Top Products
89
MAINTENANCE AND LUBRICATION
Battery
Battery Installation
1. Set the battery in the
battery holder.
2. Install the battery
vent tube. NOTE: It
must be free of
obstructions and
securely installed. If
not, battery gases
could accumulate and
cause an explosion. The tube should be routed
away from the frame and body to prevent
corrosion. Avoid skin contact with electrolyte,
which can cause severe burns.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Apply dielectric grease to each cable.
6. Reinstall the battery cover and attach the
hold-down straps.
7. Verify that cables are properly routed.
NOTE: When installing a new battery, make sure it’s
fully charged prior to its initial use. Using a new
battery that has not been fully charged can damage the
battery and result in a shorter life. It can also hinder
vehicle performance.
Battery Storage
1. Remove the battery. Clean the casing and terminals
with baking soda and water (one tablespoon of
baking soda to one cup water). Apply dielectric
grease or petroleum jelly to battery terminals and
all exposed cable connectors.
2. Top off the battery with distilled water and charge
it to a specific gravity of 1.26.
3. Recharge the battery monthly to prevent battery
discharge and sulfating or use a Polaris Battery
Tendert battery charger or similar trickle charger
to maintain the charge during the storage period.
Follow the instructions provided with the charger.
4. Store the battery in a cool, dry place out of direct
sunlight.
1
Red (+)Black (-)