Filter
Top Products
79
MAINTENANCE AND LUBRICATION
Lubrication
Proper lubrication and corrosion protection are
necessary to maintain optimum performance and
ensure years of service from your watercraft. We
recommend the use of Polaris All Season Premium
Grease. See page 101 for part numbers of Polaris
products.
Throttle Cable
1. Lubricate the throttle cable by depressing the
throttle lever and squirting grease onto the cable.
2. Push and release the throttle several times to work
the grease down the cable.
Steering Cable Joints and Inner Wire
1. Lubricate the steering cable joints on the steering
nozzle end.
2. Expose the steering cable inner cable and apply
grease. Lubricate the steering nozzle end and the
handlebar end.
NOTE: Cable seals can be moved to allow grease into
the cable. Make sure the seals are put back in the
proper location after applying grease.
Drive Line
The drive line consists of a drive shaft spider coupler
and a bearing carrier with a sealed bearing inside. It
does not require routine greasing. However, grease is
required during reassembly of the system when it’s
been disassembled for service. Grease must be applied
to the drive shaft before it’s installed through the
bearing carrier. NOTE: We recommend that all drive
line service be performed by your Polaris dealer.
Inspect the rubber spider coupler (1) monthly. See
your Polaris dealer for replacement if wear or damage
is found.
Inspect the bearing carrier (2) for water leaks through
or around the drive shaft. See your Polaris dealer for
replacement if a leak is detected.
CAUTION
Failure to apply grease to the driveshaft during
reassembly through the bearing carrier will result in
dislodged seals and improper operation of the
system. Always apply grease when reassembling.