Q-Logic FC2354601-00 A Marine RADAR User Manual


 
10 Solaris SPARC Driver Installation
Installing the Solaris SPARC Driver from the QLogic
Web Site
10-2 FC2354601-00 A
9. At the command prompt, type:
pkgadd -d ./qla2300
10. Continue with step 7 in section 10.3.
10.3
Installing the Solaris SPARC Driver from the QLogic Web Site
Perform the following steps to download the Solaris SPARC driver from the web to
your hard disk, then install the driver on your system.
NOTE: To install the QLA2300 driver, you must have superuser privileges.
1. Log on to the system as a superuser.
2. Download the driver package from the QLogic Web site
(http://www.qlogic.com) to a directory on the Solaris machines hard disk.
3. At the command prompt, change the directory (cd) to the directory where
the file was downloaded.
4. At the command prompt, type:
uncompress ./qla2300.Z
5. Step 4 produces a file in the same directory called qla2300.
6. At the command prompt in the directory where the file was uncompressed,
type:
pkgadd -d ./qla2300
7. You are prompted to select a driver package. For example:
The following packages are available:
1 QLA2300-1 QLogic QLA2300 driver
(sparc) Solaris 2.6, Rev=X.XX
2 QLA2300-2 QLogic QLA2300 driver
(sparc) Solaris 2.7, Rev=X.XX
3 QLA2300-3 QLogic QLA2300 driver
(sparc) Solaris 8-9, Rev=X.XX
Select package(s) you wish to process (or all
to process all packages). (default: all)
[?,??,q]: 3
NOTE: The revision number, X.XX, indicates the most recent version of
the driver.
8. Type the number associated with the Solaris SPARC version on your system
and press ENTER to continue.