Filter
Top Products
3 – QLA2342/2342L
Fast!UTIL
FC2354601-00 A 3-7
Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL
selectable boot setting. To boot from an FC hard disk attached to the
QLA2342/2342L HBA, select the QLA2342/2342L HBA FC hard disk on the system
BIOS.
NOTE: This option applies only to hard disks; it does not apply to tape drives and
other nondisk devices.
3.3.2.3
Restore Default Settings
The Restore Defaults option from the Configuration Settings menu restores the
QLA2342/2342L HBA default settings.
3.3.2.4
Raw NVRAM Data
This option displays the adapter’s NVRAM contents in hexadecimal format. This is
a QLogic troubleshooting tool; you cannot modify the data.
3.3.2.5
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter
Settings. The default settings for the QLA2342/2342L HBA are listed in table 3-2
and described in the following paragraphs.
Table 3-2. Advanced Adapter Settings
Setting Options Default
Execution Throttle 1–256 16
Fast Command Posting Enabled, Disabled Disabled
>4GByte Addressing Enabled, Disabled Disabled
Luns per Target 0, 8, 16, 32, 64, 128, 256 8
Enable LIP Reset Yes, No No
Enable LIP Full Login Yes, No Yes
Enable Target Reset Yes, No Yes
Login Retry Count 0–255 8
Port Down Retry Count 0–255 30
Drivers Load RISC Code Enabled, Disabled Enabled
Enable Database Updates Yes, No No