Filter
Top Products
30
• Be sure that the chassis ground connection is secure.
• Replace old ignition wires with new, high-voltage, noise sup-
pression wires.
• Install noise suppressors on your spark plugs, or install new
spark plugs that have built in noise suppressors.
• If problems persist, check your alternator/generator and reg-
ulator gauges. You can reduce the noise from these sources
by using bypass capacitors at the various output voltage
points.
Your local RadioShack store has a wide selection of noise sup-
pression accessories.
REPLACING THE FUSE
If the HTX-10 stops operating, you might need to replace the red
power wire’s fuse with the supplied spare fuse.
Caution:
Do not use a fuse with ratings other than those speci-
fied here. Doing so might damage your transceiver.
Follow these steps to replace your transceiver’s fuse.
1. Make sure the power source and transceiver are both off.
2. Pull the latches apart on the fuse holder until it opens.
3. If the fuse is blown, replace it. Use only a standard 1
1
/
4
×
1
/
4
inch fast-acting fuse with the proper rating. The fuse must
be 10 amps.
19-1110.fm Page 30 Friday, March 24, 2000 9:42 AM