Filter
Top Products
30 S1000 Autopilot Installation Guide
3.
If the outboard motor(s) does/do not move correctly, DO NOT USE THE BOAT. At the
S100 Remote, hold down STANDBY for 2 seconds to leave Setup mode and return to
Standby mode, then check that the S1000 components have been installed correctly. In
particular, check that the autopilot pump wiring and hydraulics are connected
correctly.
D7705-2
Hold down < and > in turn, and as each of these is pressed, ensure that the outboard
motor(s) turn(s) to give the correct direction of steer.
2.
Checking direction of turn - sheet 2
87040_5.book Page 30 Monday, April 30, 2007 5:58 PM